GridView Grid View Search for a disk... MainWindow QDiskInfo <html><head/><body>Health Status</body></html> <html><head/><body>Good100 %</body></html> <html><head/><body>Temperature</body></html> <html><head/><body>23° C</body></html> Firmware Serial Number Protocol Device Node <html><head/><body>Good 100 %</body></html> Type Total Host Reads Total Host Writes Rotation Rate Power On Count Power On Hours <html><head/><body>Hard Drive Name</body></html> File Settings &Help De&vice Disk &Quit &Refresh Devices &GitHub &About QDiskInfo &Ignore C4 (Reallocated Event Count) &Convert Raw values to HEX &Use Fahrenheit Self Test Cyclic &Navigation Use &GB instead of TB About &Qt Start Self Test Self Test Log Critical Warning Grown Defect List Good Caution Bad Unknown Status count hours Short Conveyance Extended Min.) Read Write Verify ID Attribute Name Raw Values Available spare capacity has fallen below the threshold Temperature error (Overheat or Overcool) NVM subsystem reliability has been degraded Media has been placed in Read Only Mode Volatile memory backup device has Failed Persistent memory region has become Read-Only Current Worst Threshold Empty JSON The JSON is empty Save JSON JSON (*.json);;All Files (*) Unable to open file for writing An ATA and NVMe S.M.A.R.T. data viewer for Linux Licensed under the GNU G.P.L. Version 3 Made by Samantas5855 Version About QDiskInfo About Qt Clear &Settings ASCII View QDiskInfo Error QDiskInfo needs root access in order to read S.M.A.R.T. data! Save Binary Data Binary Files (*.bin);;All Files (*) Success Binary data saved successfully. &Save (JSON) Ctrl+T Grid View Save (Image) Save Image PNG Files (*.png) QObject QDiskInfo Error QDiskInfo needs root access in order to read S.M.A.R.T. data! smartctl was not found, please install it! QDiskInfo needs root access in order to abort a self-test! Test Requested The self-test has been aborted Error: Something went wrong QDiskInfo needs root access in order to request a self-test! remaining completed Test Already Running A self-test is already being performed You can press the Ok button in order to abort the test that is currently running A self-test has been requested successfully It will be completed after minutes Clear Settings Are you sure you want to clear the settings saved on disk?